Trying to bring out the snares? The Pultec EQP-1A3 is one such unit. I don't even think about the pitch unless I hear something quirky and I will check the pitch at each batter head lug and bring them around but, otherwise, it is all about ease of playing and rebound, not pitch. By Emerson Maningo on September 12, 2011 ... the one that is used will be the 10,000Hz while the 500Hz will be cut using EQ. Also be sure that any two mics on one drum, like snare top and bottom, add together with the best phase response, usually resulting in more powerful low frequencies. Need to fatten it up a bit? Finding Nasty Frequencies When it comes to subtractive vs additive EQ, think of it this way: cut out the bad and enhance the good. DRUMS KEYS ALTO SAX (REED BUZZ 6-7k) THE FREQUENCY SPECTRUM, INSTRUMENT RANGES, AND EQ TIPS HONK 250-300 Hz SQUAWK 1k HONK 400 Hz SQUAWK 2k TENOR SAX (REED BUZZ 5-6k) (SAX CLOSE MIC’D KEY NOISE SET HPF @ 200 Hz) This document ©2003 Waterline Media, Inc. For personal and educational not-for-profit use only. 250Hz-400Hz is the muddy area of the snare drum. EQ Tips and Frequencies for Snare Drum Ring in a Snare. Most any software or hardware EQ will do the trick when it comes to EQing the snare, but some EQs are really special. To get a snappy snare sound then boost around 6kHz-8kHz this will also add presence to the snare drum. No problem. I have always tensioned my snare drums for feel and snare response, never pitch. 2kHz to 3.5kHz is where you’ll find the crunch of the snare drum. It’s really not that difficult to EQ a snare drum once you’ve got the hang of it. Step 1 | LP Filter at 100 Hz Snare Drum: There are two main frequencies concerning the snare drum: the fundamental pitch of the snare drum (between 200-250Hz) and the attack/clarity (5KHz and above). Find The Fat Frequency. Drum Frequencies of Kick Bass Drum, Hi Hats, Snare and Crash Cymbals. The warmth of a snare drum is mostly found around 120Hz-200Hz this part of the spectrum fills out the snare drum. Reach up to 6kHz–8kHz. To emphasize the phatness and punch of the snare drum a … The key to using an EQ to fatten up a snare is to go searching for the fat frequency. Just grab your stock EQ and let’s get to work. Whenever I EQ, I always start from the low-frequencies and work my way up. This goes to say that: “Central frequencies of drum instruments at which you can cut and boost using EQ depends on the recorded material, the type of drum materials used and the manner how they are recorded” Therefore; there is … And even different brands of drum kit can have different sound. I never find a need to boost the lower frequencies of the snare drums, as it always contains more than a plentiful. Snare ring usually lingers between as low as 500Hz and as high as 900Hz (start cutting with your snare EQ around 650Hz to locate the frequency of the ringing You want a fairly narrow Q width on that band, but not too much). If it sounds tubby, then pull down 400Hz and sweep the frequency-select knob up and down until you eliminate the offending frequency. Hm. Part 14 of 31 – Working with a thin, maybe weak sounding snare drum in the mix? Also the type and skin of the snare drum can also affect the resulting central frequency.